What Do You Know About This Device ? | Interesting Analysis About OTCX1

 OTCX1 ANALYSIS | Antigravity Devices Community

 The coil within the central accumulator has a space to wind an actuating coil.

 The central accumulator however is different in this image.  It can be wound with a resonance coil, and use a bifilar flat coil inside as the primary actuating coil, conducting the high volt collapse of electromagnetic fields. The collapse of the electromagnetic fields from the outer electromagnets occur over the utrons. 

 Just as a reactionless power cell can create mass, then the collapse of the electromagnetic field poles also is responsible for creating more output than input ultimately, as in the case of a Bedini Overunity System, but does not create heavy mass due to its negative energy characteristics.   This then describes the collapse of a buildup of electromagnetic mass, carried through vortex generated by the utrons. 

In Tesla energy theory, the spark collapse does not conduct the direct mass of electrons, but conducts the raw energy field responsible for creating electron-mass, but with no power loss due to the transfer of electron-mass. That is why Tesla used induction motors, and induction generators, and induction coils, because there was no power loss due to Newtonian inertia of electron mass.

However as the electromagnets collapse over the utrons, there is no static field path for the collapse of the ENERGY to travel through (no Electrostatic corridor over the inductive plates that acts as a wireless conductive energy corridor).  But when the system reaches a fast motion, the energy field is instead conducted through the static active medium within the Resonance Cavity of the hull space, REQUIRING there to be a hull or airframe for it to work properly.

Inductive field collapse is the principle driver of Bedini overunity circuitry.  This still has yet to be worked out in the OTC-X1, because instead of a coil, there is a monopole above and below the utron halves (whereas Bedini circuitry works on one side and the other side of a coil, driven by the coil's electromagnetic field polarity).  

The field collapse nonetheless carries negative energy to the central accumulator.  The two halves of the Central Accumulator represent the run/power battery, and the charge battery, but in advanced circuitry provided by Matrix Le, both halves (both batteries) can be charged -- the run battery can also be charging as it is running, without getting hot.  

The utrons hold negative energy resonance and capacitance and are field generators. The Magneto-electrostaic aspect is mono-polar, creating electrical vacuum on the outside, and drawing that vacuum to the center, accumulating high volt Negative electron Mass. ​As the electromagnet field coils (c-shaped) turn the rotor, it draws across a magneto-static charged Mono-Pole of the utron/accumulator frame (disk), inducing motion, without displacing the magneto-static charged field on the charge plates.  

This creates additional motion of charge and accelerated pressure of voltage.  A direct connection of electromagnetic current will displace the magneto-electrostatic charged plate surfaces.  That is to be avoided.   It is possible a spark may jump to the utron from the C- Shaped electromagnetics.  

If they are "resonance-wound" however (a single winding layer), then the whole system would have to be reversed with the Negative Charges in center, and the Positive static Charges the outside, and a separate external power source would have to be used to create a charged field around the outside, and I don't think that's the case, but it might be. At one end of the longitudinal flat plane path there will be a negative static force that feels like electrical water, and at the other end, there will be a positive static force that feels like dangerous voltage, which is how scalar fields work.